Product ID:ADCOSIL LC, 000160
MSDS Date:06/01/1986
FSC:6810
NIIN:00N077864
MSDS Number: CGYKS

ASHLAND OIL INC

COLUMBUS, OH 43216
US

Emergency Phone: 606-324-1133

Info Phone: 614-888-3333

Cage: 60016

ASHLAND OIL INC ASHLAND CHEMICAL CO DIV

2219 KENT, WA 98031 US

Telephone: 614-790-3333/800-274-5263

Cage: 60016

SODIUM SILICATE

CAS: 1344-09-8

Fraction By Weight: 45-50%

OSHA PEL N/K

ACGIH TLV: N/K

WATER

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 50-55%

OSHA PEL N/K

ACGIH TLV: N/K

ANOTHER CONTAINER, NEUTRALIZE WITH

RTECS: 9999999ZZ

OF WATER I/A/W/APPLICABLE REGULATIONS. DEPOSIT SLUDGE

RTECS: 9999999ZZ

ENGINEERING OR ADMINISTRATIVE CONTROLS SHOULD BE

RTECS: 9999999ZZ

SUSPECTED OR APPARENT ADVERSE EFFECTS).

RTECS: 9999999ZZ

AND FULL LENGTH FACESHIELD .

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: CAUSES SEVERE IRRITATION AND
DAMAGE WHICH IS LIKELY TO LEAD TO IMPAIRMENT OR LOSS OF VISION.
SKIN: CAN CAUSE SEVERE IRRITATION AND EXCESSIVE OR PROLONGED
CONTACT CAN RESULT IN BLISTERS AND BURN S. INHAL: MIST OR DUST CAN
CAUSE SEVEREIRRITATION TO THE RESPIRATORY TRACT AND MUCOUS
MEMBRANES (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:AND IF EXPOSURE IS EXTENSIVE, MAY
RESULT IN TISSUE DAMAGE. INGEST: IRRITATING AND CORROSIVE TO MUCOUS
MEMBRANES, OVEREXPOSURE CAN RESULT IN DEATH.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:SKIN:IMMED FLUSH EXPOSED AREA W/H*2O FOR AT LEAST 15 MINS,
GET MED ATTN. REMOVE CONTAMD CLTHG. LAUNDER CONTAM CLTHG BEFORE
RE-USE. DISCARD CONTAM SHOES. EYES:IMMED FLUSH W/LRG AMTS OF H*2O
FOR AT LEAS T 15 MIN, LIFTING UPPER & LOWER LIDS OCCAS. GET IMMED
MED ATTN. IF MD IS NOT IMMED AVAIL, CONTINUE FLUSHING W/H*2O. DO
NOT USE CHEM ANTIDOTE. INGEST:DO NOT INDUCE VOMIT. VOMIT WILL CAUSE
(SUPDAT)

Flash Point Method:SCC
Flash Point:>201F,>94C
Extinguishing Media:MEDIA SUITABLE FOR SURROUNDING FIRE .
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:NOT APPLICABLE.

Spill Release Procedures:SMALL SPILLS: COVER WITH SODA ASH. MIX AND
SCOOP INTO A BEAKER OF WATER. LARGE SPILL: COLLECT AND ADD SLOWLY
TO LARGE VOLUME OF WATER.
Neutralizing Agent:6M-HYDROCHLORIC ACID.

Handling and Storage Precautions:THIS MATL MAY BE HAZ WHEN EMPTIED,
SINCE EMPTIED CNTNRS PRODUCT RESIDUES (VAPS, LIQ, AND/OR SOLID),
ALL HAZ PRECAUTIONS THIS SHEET MUST BE OBSERVED.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:IF OVEREXP HAS BEEN DETERM/DOCUMENTED, NIOSH
APPRVD AIR SUPPLIED RESP IF ADVISED IN ABSENCE OF PROPER ENVIRON
CTL, OSHA REGS ALSO PERMIT OTHER NIOSH RESP UNDER SPECIFIED CNDTNS.
(SEE YOUR SAFETY EQUIP SUPPLIER). (ING 5)
Ventilation:PROVIDE SUFFICIENT MECH (GEN &/LOC EXHST) VENT TO MAINTAIN
EXPOS BELOW LEVEL OF OVEREXP (FROM KNOWN, (ING 6)
Protective Gloves:RESISTANT GLOVES/NATURAL RUB/NEOPRENE.
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS (ING 7)
Other Protective Equipment:ANSI APPRVD EMER EYE WASH & DELUGE SHOWER .
TO PREVENT SKIN CONTACT, WEAR IMPERVIOUS CLOTHING AND BOOTS.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
VP:<17.60 @ 20C. FIRST AID PROC:FURTHER DMG TO THROAT, DILUTE BY GIVING
H*2O. GIVE MILK OF MAGNESIA. KEEP WARM, QUIET, GET MED ATTN IMMED.
INHAL:IF AFFECTED REMOVE INDIVIDUAL TO FRESH AIR. IF BRTHG IS
DFCLT, ADMIN OXYGEN. IF BRTHG HAS STOPPED GIVE ARTF RESP. KEEP PERS
WARM, QUIET AND GET MEDICAL ATTENTION.

Boiling Pt:B.P. Text:230F,110C
Vapor Pres:SUPDAT
Spec Gravity:1.58 @ 60F
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:70.76

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG MINERAL ACIDS, STRONG ORGANIC ACIDS, REACTIVE
METALS SUCH AS ALUMINUM AND MAGNESIUM, ZINC.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:THERMAL DECOMPOSITION OR COMBUSTION
MAY PRODUCE SILICATE, HYDROGEN.
Conditions to Avoid Polymerization:AVOID CONTACT WITH STRONG MINERAL
ACIDS AND STRONG ORGANIC ACIDS.

Waste Disposal Methods:SMALL SPILL:DISSOLVE IN LRG AMT OF H*2O & SODA
ASH. NEUT W/6M-HYDROCHLORIC ACID. FLUSH DOWN DRAIN W/EXCESS H*2O
I/A/W/APPLIC REGS. LRG SPILL:COLLECT & ADD TO LRG CNTNR OF H*2O,
STIR IN SLIGHT EXCESS O F SODA ASH. LET STAND 24 HRS. DECANT INTO
(ING 3)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.